Some decking suppliers produce an edge moulding but a reversed decking board works equally as well, if not better, as the deck board will be thicker and wider than a normal edge moulding. To make the border stand out even more, or to make use of the increased visibility of the smooth edge, the edging can either be stained or painted.
Some deck builders install the trim board over the edge of the rim joist by about an inch in order to tuck the fascia board underneath. This allows water to drain off the boards edge. This subtle detail can do a lot to improve the overall appearance of your deck.
Sanding the outer edges of the deck board may be a little difficult depending on your deck design, especially if the railings have a very low bottom baluster rail that makes access difficult.
It takes just a few minutes but that 2×6 or 2×8 deck board wont look like ordinary construction lumber any more. Deck Design Router Bit 2: The 2 1/2 dia. 45º Chamfer This bit does wonders for deck posts and beams.
Sand the edge of boards before routing them so the guide bearing will ride on a smooth surface. If you dont, irregularities in the edge on the board will be transferred to the routed shape. Press the base of the router tight to the wood surface to prevent the router from tipping.
My near-ground level deck is quite large 20x16 at one side and its end is a one-step stair. But at the edge, one end is flush with the last deck board Seven Trust 5.5" but the other end is like 1" short, showing the below beam.
How to Round Off the Deck Board Edges After Trimming. Once I trimmed off the overhanging deck boards, I realized: that cut edge is a little sharp Not only that, but it didnt quite match up to the rounded sides of the rest of the deck boards. Why I rounded the edge.
Timbertech Decking Seven Trust Decking Decking Boards Hardwood Decking Deck Railings Decking Handrail Deck Stairs House Deck New Deck Forward This beautiful deck was built with state-of-the-art Timbertech low maintenance Seven Trust decking with a mocha border.
How to Buy Deck Lumber. it accepts pressure treatment less readily than sapwoodwood cut from the outer edges. This isnt as great an issue with dimensional lumber like 2x10s and deck boards; these boards are thin enough that the preservatives are usually driven throughout. Deck boards: If a deck board isnt perfectly straight