Steelrite uses a light gauge steel construction systems approach to provide turn-key framing packages and solutions for mid-rise hotels, condos, apartments, senior housing, military housing, student housing, and office buildings.
Do not exceed load-carrying capacity of composite floor joist system with construction loads. 2. Concentrated construction loads: Do not place loads i.e. bundles of plywood, mesh, sheetrock or Rollbars , exceeding the design load of the slab, on joist system, but rather on supporting walls or beam.
*The D500 system combines Hambro composite steel joists with a poured concrete slab, using the bottom chord of the joist as a tension member with the top chord performing as a compression member, then as a shear connector after the pour.
These benefits make Hambro Composite Floor System a product of choice for any fire rated assemblies which require a drywall finish ceiling whether it's condos, apartments, hotels, senior housing
The Hambro D500 composite floor system is your cost-effective answer to solid, reliable elevated slabs supported by proven floor joists. Compatible with all traditional structural systems, the Hambro D500 floor combines the flexibility of the D500 joists with the strength of a reinforced concrete slab.
Hambro D510 - Concrete Floor Systems The D510 composite lightweight floor system is Hambros shortspan alternative to answer elevated floor construction requirements. Hybrid concrete/steel T-beams run in one direction, with an integrated continuous slab spanning the other direction, combining to form a mini-beam section with poured concrete.
ing to pay a big premium or those who had special requirements. But now four floor systems are well suited to small buildings. All incorpo- and reinforce-ment is optional because it serves only to control cracking. Utilities and wallboard tives of the Hambro division of the Canam Manac Group, a construction
requirements where required siding, stucco, brick, stone or other exterior approved multi level concrete floor system, hambro, speed floor or composite steel deck, engineered floor system. engineered floor system. reinforcing steel connection specified by floor system manufacturer. 2% slope f is g a e
Hambro Concrete Composite Floor Systems www.hambro-floors.ws are ideal for multi-story commercial and single-family homebuilders seeking quality and stability. The Hambro D500 features a steel joist top chord embedded in concrete.
This information is provided as a basic guide of recommended techniques for the installation of the Hambro Composite Floor System. It is not intended to take the place of the requirements of applicable building codes.
The Hambro transfer slab is a floor system that transfers the superimposed loads from the structural building frame above the slab to the columns, walls and foundations below. This system is economical and lighter than conventional reinforced concrete slabs.
The floor slab is a 3 thick 3,000psi concrete with 6 x 6 W2.9 x W2.9 welded wire fabric, this particular floor thinness was pick to give the system a 2 hours system. The slab is than supported by a 20 deep Hambro bar joist.
Hambro D-500 Steel composite floor joist system is an advanced up-to-date answer to elevated floor construction challenges. Combining steel joists with poured concrete, the system consists of
Hambro - Concrete Floor Systems Hambro designs, fabricates and sells a concrete floor system designed primarily for the multi-family housing and commercial construction markets. Hambros concrete floor system fits perfectly with a variety of wall types: Masonry, steel frame, metal stud, pre-cast walls, ICF blocks and wood walls.
Introduction Hambro COMPOSITE FLOOR SYSTEMS Page 1.00 This manual has been and torsional stability to the entire Hambro Floor System during the concreting stage. meet the requirements of the Building Officials and Code Administrators International, Inc.
Hambro Floor Joist Systems Spacecon > Services > Architectural Finishes > Hambro Floor Joist Systems We are qualified installers of The Hambro D500 Floor System, which combines composite joists with poured concrete, developing a hybrid concrete and steel T-beam running in one direction and an integrated, continuous slab in the opposite direction.
2 The Hambro floor system uses a specially design steel bar joist with a S shape top compression chord that serves three functions, a compression member in the non-composite joist during
The Hambro D500 composite floor system is composed of steel joists and a concrete slab reinforced with wire mesh. which help reinforce the bond between the steel/concrete interface. 4 REINFORCED CONCRETE SLAB The concrete slab is designed as a continuous, one-way slab in order to carry loads the Hambro composite floor system, Econox